datasheet, circuit, data sheet: TI – SYNCHRONOUS 4-BIT COUNTERS,alldatasheet, datasheet, Datasheet search site for Electronic. These synchronous, presettable counters feature an inter- nal carry look-ahead for application in high-speed counting designs. The DM74LSA and. 74LS datasheet, 74LS pdf, 74LS data sheet, datasheet, data sheet, pdf, Fairchild Semiconductor, Synchronous 4-Bit Binary Counters.
|Published (Last):||20 September 2009|
|PDF File Size:||7.89 Mb|
|ePub File Size:||16.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
I am especially looking for information concerning the “old 70s design” you want to simulate.
Datasheet PDF –
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Message 9 of Thanks for sharing these files over here! Message 4 of Message 2 of This datawheet not the case when connecting to ENP.
In the schematics the rco is connected to ENT. Most Active Software Boards: Please find attached the multisim model. Unfortunately it did not solve my headache.
datasheet & applicatoin notes – Datasheet Archive
Message 6 of But, when the second counter’s RCO carries over to the third counters ENT it stays high for a long period of time the duration of the QA and sets off the third counter to “race at clock speed” similar to the first counter. The case is not solved – and I have now asked the moderator to remove the duplicate. I am new to NI tools and new to dataxheet forums.
Message 5 of For some reason i couldnt attach files with my message above, and i cannot post them separately either it appears Message 8 of I tried to dahasheet the 7411 cascade in another simulation tool – and i get the reverse and expeced results; that when RCO is connect to ENT, the carry is forwarded and no “racing” occurs.
Can you provide me with the following information to help the troubleshooting?
Message 10 of Message 7 of I am asking because I found another post in this board that noted that the issue was resolved. Datasneet connected to ENT as it appears to be done in the orignal schematics p21, B4 to E4 the third counter starts to race at clock speed when RCO set ENT high as can be seen in the attached simulation screen shot.
Is the model that is being used in there shareable? I am building a simulation of an old 70s design based on s and I have had a lot of trouble getting a set of counters to operate according to my expectations.
They should form a simple 16 bit binary counter that keeps incrementing until all of the output bits for E4 are all zeros and then it loads all the counters with preset value.
Message 3 of Message 1 of I appreciate any insights. Do you have any information about the simulation tool you are comparing to?
Thanks in advance for your feedback! Something wrong with the model? Question to the forum: In my search for understanding more I discovered a recent document that had identified an error in the multisim model related to the counter executing on falling edge of clock, should be rising edge.